Getting Started
This page describes the steps for updating the Viewer program of "Terminal Authentication type" (for remote device) to the latest version.

Steps
■Step 1
Logon to the PC that "Terminal Authentication type" Viewer program has been installed.
■Step 2
Please confirm the edition you are using.
- On the Desktop or from the Start Menu, go to All Programs (or All apps), open MagicConnect2.0 Viewer and check if "MC Assist" is included.
If "MC Assist" is NOT included on the list, the product you are using should be "Mobile type (Windows)."
Please stop the procedures, and follow the steps on this page. - From the list opened at step (a), please execute "MagicConnect2.0 Viewer Plus (Security check-enhanced)," or "MagicConnect2.0 Viewer" if you don’t have "MagicConnect2.0 Viewer Plus (Security check-enhanced.)"
- Click "Settings."
- Check its edition from the version information on the lower left of the screen.
For example, the image below shows that its edition is "NDL.S+."
- Please close the screen shown on step (c) and (d).
■Step 3
Download the package that corresponds to the confirmed edition in Step 2.
*The version information can be found at settings screen of viewer program.
■Step 4
Execute the setup program "mcviewer20_setup_***_mc_assist.exe" you have downloaded.
■Step 5
When the setup program starts, follow the instructions on the screen and proceed the setup.
■Step 6
Click "Finish" when the update completion screen is shown.
Please delete "mcviewer20_setup_***_mc_assist.exe."
This completes the updating steps.